renegade gear

[Gerald_Miller]

What gear is needed for here in renegade?
Submitted via Mobile Device

[Wall Banger]

What gear is needed for here in renegade?
Submitted via Mobile Device 6/42 - 7:00 or a 6/43 - 7:16 ratio will do quiet well, but ya better have a good bottom end.
:first:

[Sudduth49]

In a renegade car, you can run a 6.20 or 6.50 and be fine.

[Wall Banger]

In a renegade car, you can run a 6.20 or 6.50 and be fine. We only run there once this year and we run the gear we run at CCS, a 6:50 and only turned 6800. Definately needed more gear.

[duke87]

What gear is needed for here in renegade?
Submitted via Mobile Devicegerald we had a 620 in the limited and turned 7400.....stowes had a 708 i think in their renegade and said it was way too much...

[Wall Banger]

gerald we had a 620 in the limited and turned 7400.....stowes had a 708 i think in their renegade and said it was way too much... Better check your tach, or your spinning your tires. We run 6:50 at CCS and it is way bigger than Harris. just sayin', besides, I'm sure you know that you choose your gear ratio to tire size and to where the power curve on your camshaft is at, so there is no set ratio to run, it's what works best with your combination.

[Gerald_Miller]

thanks everyone I have no clue on this v8 stuff i just need in the ballpark dont want to be out in left field.

[steve0]

5.83 in Street stock car turns 6700 at CCS.....We were told 6.20 or so at Harris...

[Wall Banger]

thanks everyone I have no clue on this v8 stuff i just need in the ballpark dont want to be out in left field. If you're accustomed to running four cylinders, it is a whole different animal than the V/8 classes. Mainly, you're pulling much more weight and need more gear to pull you off the corner where in the fours your try to keep your rpm's up. Pulling a 7:00 is at the upper end of what you would want to turn a renegade motor and you should have good stuff if you plan on running it. I don't know but if you're just starting out in the gade class, you may want to start with a 20 0r a 50 until you get the hang of things, but if you want to run out front you will have to have more gear.

[meathead 13A]

Correction 620 at ccs and 650 harris still need more gear at harris. 650 was only like 6800 rpms at harris.

[Pit_Man_88]

was going to say i call bull crap on running a 650 at ccs .gerald i think with the engine u have its going be ok with a 650.we can always take one of kieths t10 trans and a 620 gear and run a 775.

[77bennett77]

we ran a 6.20 and wasnt enough. hope this helps. i think the devil gear will be perfect for there,jmo